Archiving hint: In late summer 2023, Github started to enforce 2FA (Two Factor
Authentication), so I had to archive the repository before
losing control over it. See also Traumflug#338
At the point of archiving, Teacup Firmware happens to work
just fine within the limits of ATmegas, Cortex-Ms and 32-bit
integers. Performance is as excellent as it can get. Which
is why development pretty much ceased a while ago already,
simply because there was nothing left to fix or to improve.
A masterpiece of low-level embedded software.
Traumflug, August 2023
##############################################################################
Teacup - lean and efficient firmware for RepRap printers
by Triffid Hunter, Traumflug, jakepoz, many others.
##############################################################################
For installation instructions, see
http://reprap.org/wiki/Teacup_Firmware#Simple_Installation and/or
http://reprap.org/wiki/Teacup_Firmware#Developer_Installation
For documentation, see
http://reprap.org/wiki/Teacup_Firmware
##############################################################################
This firmware is Copyright (c) ...
2009 - 2010 Michael Moon aka Triffid_Hunter
2010 - 2013 Markus "Traumflug" Hitter mah@jump-ing.de
This program is free software; you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation; either version 2 of the License, or
(at your option) any later version.
This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
GNU General Public License for more details.
You should have received a copy of the GNU General Public License
along with this program; if not, write to the Free Software
Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
##############################################################################